1水冷式冷凝器的保養
Maintenance of 1 water cooled condenser
（1）適時排除冷凝器包養不凝性氣體和潤滑油。
(1) at the right time, the condenser is excluded from the non condensable gas and lubricating oil.
（2）根據精密空調冷卻水系統的運行情況，定期清洗冷卻塔接水盤和管道系統中設置的除污器、水過濾器。
(2) according to the operation of the cooling water system of the precision air conditioning, clean the pollution remover and water filter set in the water tray and the pipe system on the cooling tower regularly.
（3）加強精密空調冷卻水水質的檢測，發現水質惡化，要將系統中使用的冷卻水部分或全部置換。
(3) strengthen the inspection of the water quality of the cooling water of the precision air conditioning, find that the water quality is deteriorating, and the cooling water used in the system should be partially or completely replaced.
（4）注意精密空調冷凝器傳熱管的結垢情況，如果結垢嚴重，應及時除垢。為減緩結垢，可在冷卻水中加入適量阻垢劑。也可以采用經水處理的冷卻水。
(4) pay attention to the scaling of the heat transfer tube in the condenser of the precision air conditioner. If the scale is serious, it should be descaled in time. In order to slow down scaling, a proper amount of scale inhibitor can be added in the cooling water. Water treated water can also be used.
2風冷式冷凝器的保養
Maintenance of 2 air-cooled condenser
對于精密空調風冷式冷凝器的正常保養主要是根據傳熱翅片上積灰情況，定期進行吹除或清洗，以保持傳熱面的清潔。
For the precise air-conditioned air-cooled condenser, the normal maintenance is mainly based on the deposition of dust on the heat transfer fins, and regularly purge or clean to keep the heat transfer surface clean.
3冷卻空氣用蒸發器的保養
3 maintenance of evaporator for cooling air
（1）定期吹除或沖洗蒸發器傳熱翹片上的積灰;
(1) periodically blow or flush the ash on the heat transfer warp of the evaporator;
（2）冷庫用蒸發器，根據排管表面霜層的厚度及時除霜;
(2) cold storage with evaporator, defrost in time according to the thickness of the frosting layer on the surface of the tube.
4其它輔助設備的保養
4 maintenance of other auxiliary equipment
（1）干燥過濾器：要隨時注意液流指示器對制冷劑含水量的指示，當它的指示片為淡紅色時，干澡過濾器中的干燥劑失效，應立即更換干燥劑。
(1) drying filter: we should always pay attention to the indication of liquid flow indicator to the moisture content of refrigerant. When its indicator piece is light red, the desiccant in dry bath filter fails, and desiccant should be changed immediately.
（2）中間冷卻器、氣液分離器：定期對浮球閥進行檢查以及在機組大修時進行吹除和承壓試驗，分離器中有加熱裝置時還應定檢查加熱裝置。
(2) intercooler and gas-liquid separator: check the float valve regularly and carry out the blow up and pressure test during the overhaul of the unit. The heating device should also be inspected when the heating device is in the separator.